HP StorageWorks P9000 - Disk Arrays User Manual

Table 59 Error codes (part code 7005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WAssociate the specified Thin Provisioning
volume with a pool, then retry the
operation.
The command was rejected, because the
Thin Provisioning volume specified as a
reserved volume was not associated with
a pool.
750047005
WSet an LU path to the specified P-VOL,
then retry the operation.
The command was rejected, because no
LU path was set to the volume specified
as P-VOL.
750057005
WSet an LU path to the specified P-VOL,
then retry the operation.
The command was rejected, because no
LU path was set to the volume specified
as S-VOL.
750067005
WSet an LU path to the specified P-VOL,
then retry the operation.
The command was rejected, because no
LU path was set to the volume specified
as a reserved VOL.
750077005
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified P-VOL.
780537005
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified S-VOL.
780547005
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified reserved
volume.
780557005
Part code 7007
Table 60 Error codes (part code 7007)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
60127007
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
71117007
Part code 7010
Table 61 Error codes (part code 7010)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the capacity of P-VOL and S-VOL.
Specify a volume with the same capacity,
and retry the operation.
The volume of S-VOL is different from
specified P-VOL.
51157010
WYou cannot create L1 pair for the
specified P-VOL. Delete the created L1
pair, and retry the operation.
You cannot create another L1 pair,
because the number of L1 pairs exceeds
the maximum.
51167010
WYou cannot create the specified pair.
Check the possible number of pairs to
be created.
No MU number is available.51177010
238 Message (part code group 7nnn)

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English