Part code 7105
Table 62 Error codes (part code 7105)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
50997105
WPlease contact HP Technical Support.An internal logic error occurred.56257105
WRelease the write-protection by Volume
Retention.
The specified volume cannot be used
because it is write-protected by Volume
Retention.
56267105
WWait a while, and retry the operation.Processing in progress. Please wait for
a while, and then retry the operation.
65027105
WWait a while, and retry the operation.The volume status is being changed to
simplex.
65037105
WExecute one of the following:
• Change the attribute of the Security
Group so that the Security Group can
specify T-VOL or reserved volume.
• Remove the volume specified from the
Security Group.
The command has been rejected,
because the specified volume was
registered in the Security Group that
cannot specify T-VOL or reserved volume.
65207105
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.73107105
WAdd shared memory or confirm whether
the necessary program product key is
installed.
Sufficient amount of shared memory is
not installed or the program product is
not installed.
85007105
WWait a while, and retry the operation.The command has been rejected,
because the command specified last time
is being processed.
85017105
WDelete the Remote Copy pair.You cannot reserve the volume, because
a remote copy pair exists in the same
subsystem frame.
85027105
WDelete the Remote Copy pair.You cannot create the new pair, because
a remote copy pair exists in the same
subsystem frame.
85037105
WConfirm the composition, the status, or
the volume status of the pair. (See the
Business Copy for Mainframe Systems
User Guide for the relation between the
composition of the pair, status of the
pair, or the volume status of the pair and
those operations.)
The command was rejected. Check the
composition, the status, or the volume
status of the pair.
85047105
ESee the section "Status, permitted pair
operations" in the Business Copy for
Mainframe Systems User Guide for the
relation between the status of pairs and
the commands that can be accepted.
The command has been rejected,
because the operation cannot be
accepted in the current pair status.
85057105
WVary the T-VOL or the reserved volume
offline from the mainframe host, then
issue the command again.
The command has been rejected,
because the specified T-VOL or reserved
volume is used by the host.
85067105
Part code 7105 241
To Next Page
Loading...
