Table 75 Error codes (part code 8610) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WEnter a destination e-mail address.The field of destination e-mail address is
left blank.
When the mail notification service is
enabled, destination e-mail address is
required to input.
657608610
WEnter the IP address or the host name.The IP address of the mail server is
invalid. Check the value if it is set as one
of the following.
IPv4:
• The value of each class is other than
0 to 255.
• The value of Class A or all classes is
0.
• There is a blanked class.
IPv6:
• The value of all segments is 0.
There is a blanked segment.
Host Name:
• Blanked
657618610
WEnter the items to be set, then retry
again.
You cannot send a test message,
because the items to be set are not fixed.
657628610
WEnter a destination e-mail address.The field of destination e-mail address is
left blank.
657638610
WRemove the duplicated e-mail addresses,
then register it again.
The same e-mail addresses are specified.657658610
iConfirm the message, then reply.Send a test message. OK?690818610
iConfirm the message, then reply.Sending test message has been
completed.
690828610
Part code 8805
Table 76 Error codes (part code 8805)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
50108805
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
50138805
WDelete unnecessary reports, then retry
the operation.
No more report can be made.50188805
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
50998805
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
60008805
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
60128805
278 Message (part code group 8nnn)
To Next Page
Loading...
Need help?
General