4 Message (part code group 2nnn)
This chapter includes the error messages with the part code 2005 and 2010.
Part code 2005
Table 29 Error codes (part code 2005)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSelect another volume.The specified volume cannot be set as a
command device or a component of a
LUSE volume, because it is being used
as the volume of Remote Copy, Business
Copy, Auto LUN, or Snapshot.
10022005
WSelect another volume.The specified LUSE volume cannot be
released, because it is being used as the
volume of Remote Copy, Business Copy,
Auto LUN, or Snapshot.
10062005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
10092005
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
10102005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
LU path is set to a volume which links as
an expanded LU.
10122005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The emulation types of the volumes
combined into a LUSE volume are not
the same.
10132005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
LU path is set to the releasing expanded
LU. (You need to release the expanded
LU and path at the same time.)
10152005
WThe configuration information has been
changed already.
Check the settings, and request the
configuration information setting again.
The specified volume does not exist.10212005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The number of volumes you intend to
combine into a LUSE volume exceeds the
maximum.
10282005
WCheck the settings, then retry the
operation.
The following volumes cannot be
specified when you change the
expanded LU configurations:
• Volumes that do not exist
• Volumes reserved by Auto LUN
• System Disk volume
10502005
WCorrect the specified contents, then retry
the operation.
The LUSE operation cannot be performed
because the volume is set as a command
device.
11262005
Part code 2005 71