Table 29 Error codes (part code 2005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Failed to form a LUSE volume because
the number of LUSE volumes exceeds the
maximum that can be set in a disk array
subsystem.
11372005
WCheck the specified contents.The specified LDEV is already used for
another LUSE volume.
11382005
WCheck the setting.The capacity of LUSE volume exceeds
the maximum.
11822005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
You are trying to insert in the linkage
operation including LUSE. (LDEV number
is inserted to the LDEV numbers created
in LUSE.)
11852005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
You cannot expand the LU because the
host mode of the group with paths which
are defined in the LU is corresponding
to online LUSE.
11872005
WCorrect the specified content, then retry
the operation.
The LUs cannot be combined or released
by mixing the internal and external LUs.
11962005
WCheck the attributes of the external
volumes, then retry the operation.
The LUSE volume cannot be configured
because the external volumes do not
have the same cache mode.
13622005
WConfirm that the different drive types
(SAS drive, SATA drive, and flash drive)
don't coexist, then retry the operation.
The different drive types cannot be
combined to form a LUSE volume.
13652005
WInstall the necessary license key.This functionality is not available. Open
System Array Management is required.
15992005
WInstall the necessary license key.This functionality is not available. Open
System Array Management is required.
16002005
WInstall the necessary license key.This functionality is not available. Open
System Array Management is required.
16012005
WSelect another volume.The specified volume cannot be assigned
as an LUSE volume or a command
device, and the path of the volume
cannot be set because it is being used
as a Pool volume.
19042005
WSelect another volume.There are virtual volumes and non-virtual
volumes in the volumes specified to
compose a LUSE volume.
19052005
WCheck the volume, then retry the
operation.
The specified volume is not a LUSE
volume.
19212005
WRestore the LDEVs, then retry the
operation.
LDEVs that are not normal are included
in the component of a LUSE volume.
19222005
WCheck the setting.The LDEVs to be combined are not
specified, or the number of LDEVs
exceeds the maximum number that can
be combined.
19232005
WCheck the setting.The all volumes that compose the LUSE
volume are not selected.
19242005
72 Message (part code group 2nnn)
To Next Page
Loading...
Need help?
General