Part code 9605
Table 85 Error codes (part code 9605)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
50139605
WIssue a command again.No commands are issued.50309605
WDecrease the number of commands.The number of issued commands exceeds
the maximum.
50419605
WInstall Program Product.The program product is not installed.55119605
WReview LUs, and retry the operation.The number of requests for combining
LUs does not match the number of the
LUs.
58099605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
60129605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
60239605
EIf this problem persists, please contact
HP Technical Support.
The mistake is found in the set
parameter.
60389605
WWait a few minutes, then retry the
operation.
Processing in progress. Please wait for
a while, and then retry the operation.
65029605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
65339605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
70609605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
71119605
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.73109605
WRetry a little later.An error occurred while connecting to
the subsystem. Please retry a little later.
80019605
WRetry a little later.A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
80029605
ECheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.81029605
WSpecify an open-system volume.The specified logical volume does not
exist.
81209605
WRetry a little later.This logical volume is busy.81229605
ECheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.81239605
WSpecify an open-system volume.This logical volume is a mainframe
volume.
81249605
WReview LDEV information, then retry.The attribute of the logical volume has
been changed by RAID Manager.
81259605
WCheck the logical volume configuration,
then retry the operation.
This logical volume is configured as a
command device.
81269605
Part code 9605 289