Table 54 Error codes (part code 6507) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
70706507
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
70716507
Part code 6510
Table 55 Error codes (part code 6510)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify the data that you want to register
in the SVP, and retry the operation.
The displayed information has not been
changed.
50306510
WCheck the contents, and retry.The Operation value is invalid. Specify
the correct value.
51376510
WCheck the contents, and retry.The value specified for Gathering Interval
is invalid. Specify a valid value within
the range of 1 to 15.
51386510
WSpecify the correct CU number.The specified CU number is incorrect.
Specify the correct CU number.
51406510
WSpecify the correct device number.The specified LDEV number is incorrect.
Specify the correct LDEV number.
51416510
WSpecify the correct group number.The specified GID is incorrect. Specify
the correct GID.
51426510
WSpecify the correct LUN.The specified LUN is incorrect. Specify
the correct LUN.
51436510
WCheck the values, then specify correct
values.
Some of the entered values are incorrect.
Check the values and then specify
correct values.
51446510
EPlease contact HP Technical Support.An error occurred in client logic.73016510
EPlease contact HP Technical Support.An error occurred in client logic.73026510
EPlease contact HP Technical Support.An error occurred in client logic.73036510
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
74406510
WClick [Refresh], and retry.The system cannot apply the new
configuration. Do you want to refresh?
81016510
iCheck the port type, then change cable
connections.
Exchange the channel cable connections
after confirmation of the port type.
90066510
iClick [OK].The export is complete.90096510
iTo continue processing, click [Yes]. If the
processing finishes, reconfigure the port
that is not in operation.
The Port Setting process has not
completed. Do you want to continue for
other ports?
90216510
204 Message (part code group 6nnn)
To Next Page
Loading...
Need help?
General