Table 92 Error codes (part code 20122) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s).The auto delete has already been set to
enable.
10506920122
WTo continue the processing, click [OK].
Otherwise, click [Cancel].
This operation has a possibility to cause
conflict of setting items with the task of
"In progress" or "Not run.” Note the
conflict of set items. Do you want to
continue?
10527820122
EIf the same problem persists despite
retrying, please contact HP Technical
Support.
An unexpected error occurred.10600420122
EConfirm the details of the error from the
following error code list.
An error occurred.10603920122
ECheck the details of the error from the
following error code list.
An error occurred.10605620122
ECheck the details of the error from the
following error code list.
An error occurred.10605720122
ECheck the details of the error from the
following error code list.
An error occurred.10605820122
ECheck the details of the error from the
following error code list.
An error occurred.10605920122
ECheck the details of the error from the
following error code list.
An error occurred.10606020122
ECheck the details of the error from the
following error code list.
An error occurred.10606120122
WCollapse other tree nodes, then retry the
operation.
The tree node cannot be expanded any
further.
10607220122
WTo continue processing, click [OK]. To
stop processing, click [Cancel].
Only a host registered in a group is
allowed to access a LUN that is defined
in the target group. A host that is not
registered in any group is not allowed
to access any LUN. Do you want to
continue this operation?
10607320122
WTo continue processing, click [OK]. To
stop processing, click [Cancel].
All the hosts connected to the target ports
are only allowed to access a LUN that
is defined in the group #00. This will
lead the possibility that LUNs, which are
defined in the group other than #00
being used at present, cannot be
recognized, then the file system might
be destroyed. Do you want to continue
this operation?
10607420122
WTurn the security switch on.The configuration does not become
effective until the security switch is turned
on.
10607520122
WPlease confirm contexture structure.The specified item could not be
displayed because the configuration had
been changed.
10607920122
WIf you do not want to continue, click
[Cancel] and go back to Delete LUN
Paths window, then click [Finish] to
complete.
Are you sure to execute "Shred LDEVs"?
This task execution deletes all of the
target LDEV data and the data cannot
be recovered.
10608920122
Part code 20122 303
To Next Page
Loading...
Need help?
General