Table 18 Error codes (part code 0405) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
72070405
EIsolate the abnormal section following
the procedure below:
Rebooting the PC
Checking the LAN card/LAN cable
Checking the IP address of the PC
Replacing the PC
Turning on, then off the DKC (care
should be taken.)
An error occurred during SVP
processing.
80020405
EIsolate the abnormal section following
the procedure below:
Rebooting the PC. If this does not fix the
problem:
Checking the LAN card/LAN cable. If
this does not fix the problem:
Checking the IP address of the PC. If this
does not fix the problem:
Replacing the PC. If a new PC does not
fix the problem:
Turn the DKC on, then off (care should
be taken.
The subsystem status is invalid.80030405
EContact the Support Center for the plans
of the program product to be supported
by DKCMAIN.
The DKCMAIN microcode does not
support this program product.
82020405
EPlease contact HP Technical Support.This program product needs a later
version of hardware. Please contact HP
Technical Support.
82030405
EAllocate additional shared memory, and
enable the program product.
To use this program product, it is
required to enable the program product
by allocating additional shared memory.
Add cache memory in case of need.
82040405
EPlease contact HP Technical Support.This program product remains in the
configuration. Please contact HP
Technical Support.
82050405
WStop using this program product function.This program product is in use, you
cannot remove this program.
82060405
ERetry this operation.The subsystem status is invalid.83010405
EIf the same problem persists despite
retrying, please contact HP Technical
Support.
The specified program product cannot
be removed, because the license for it is
allocated to the SLPR.
552630405
EIf the same problem persists despite
retrying, please contact HP Technical
Support.
Since the licensed capacity of SLPR0 is
insufficient, the partition capacity can't
be increased.
555060405
EIf this problem persists, please contact
HP Technical Support.
It is not possible to install it because of
PP of pre-install.
555200405
EIf the same problem persists despite
retrying, please contact HP Technical
Support.
This function cannot be used by the
storage partition administrator.
565240405
38 Message (part code group 0nnn)
To Next Page
Loading...
Need help?
General