Table 30 Error codes (part code 2010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WFollow the correct operation procedure.The specified LDEV is inaccurate.50562010
WClick [OK] to continue the operation.
Click [Cancel] to stop the operation.
Are you sure you want to perform the
LUSE operation on a volume that has a
path definition?
58122010
WSpecify the LUSE displayed in blue bold
italic characters.
There are no LUSE volumes that can be
reset. Check the specified volumes.
58152010
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The specified volumes will be expanded
to LUSE volume. All data in each LDEV
will be initialized. Do you want to
continue?
90102010
WTo continue processing, click [OK]. To
stop processing, click [Cancel].
The specified LUSE volume will be
released. All data in the volume will be
destroyed. Do you want to continue?
90602010
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The specified volumes will be expanded
to LUSE volume. Do you want to
continue?
93552010
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The selected LUSE volume will be reset.
Do you want to continue?
93582010
iTo continue this operation, click [OK].
To cancel this operation, click [Cancel].
Are you sure you want to perform the
LUSE operation using volumes that have
different CLPR numbers?
550072010
WDelete the path set to the LUSE volume,
then retry the operation.
The LUSE volume configuration cannot
be released because a path is set to the
LUSE volume. Delete the path, and then
release the LUSE volume configuration.
551122010
Part code 2010 75
To Next Page
Loading...
Need help?
General