System Diagnostics and
Troubleshooting
105
Cannot format diskette. Invalid media reported. When formatting a disk in MS-DOS, you might need to
specify diskette capacity. For example, to format a 1.44-
MB diskette, enter the following command at the MS-
DOS prompt:
FORMAT A: /F:1440
A problem has occurred with a disk
transaction.
The directory structure is bad, or
there is a problem with a file.
In Windows, right-click Start > Explore, and select a
drive. Select File > Properties > Tools. Under Error-
checking, click Check Now.
Diskette drive cannot read a diskette. Diskette is not formatted. Format the diskette.
You are using the wrong diskette
type for the drive type.
Check the type of drive that you are using and use the
correct diskette type.
You are reading the wrong drive. Check the drive letter in the path statement.
Diskette is damaged. Replace the diskette with a new one.
“Invalid system disk” message is
displayed.
A diskette that does not contain
the system files needed to start
the workstation has been inserted
in the drive.
When drive activity stops, remove the diskette and press
the Spacebar. The workstation should start up.
Diskette error has occurred. Restart the workstation by pressing the power button.
Cannot Boot from Diskette. Diskette is not bootable. Replace with a bootable diskette.
Diskette boot has been disabled
in Computer Setup.
Run Computer Setup and enable diskette boot in
Storage > Boot Order.
Removable media boot has been
disabled in Computer Setup.
Run Computer Setup and enable Removable Media Boot
in Storage > Storage Options.
Table 5-5 Diskette Problems (continued)
Problem Cause Solution
To Next Page
Loading...
Need help?
General