Removal and Replacement Procedures82
4.26 Diskette Drive
To remove a diskette drive:
1. Disconnect power from the system (section 4.2), open the access panel (section 4.9), and remove the front bezel
(section 4.12).
2. Disconnect the data 1 and power 2 cables from the back of the diskette drive.
3. Lift the green drivelock release tab 1 and gently slide the drive 2 out at the same time.
To replace a diskette drive:
1. Align the metal protrusions on the side of the drive with the grooves in the diskette drive bay and slide the diskette
drive into the bay until it stops.
2. Connect the data cable to the diskette drive 1 and to the system board 2.
3. Connect the power cable to the diskette drive.
To Next Page
Loading...
