Removal and Replacement Procedures74
4.20.5 IEEE-1394 (Optional)
To remove an IEEE-1394 card:
1. Disconnect power from the system (section 4.2), open the access panel (section 4.9) and remove the PCI card
support (section 4.20.2), if installed.
2. Lift the PCI levers 1 by first pressing down and then up.
3. Disconnect the front I/O cable and power cable 2 from the card.
4. Lift the IEEE card 3 out of the chassis. Store the card in an anti-static bag.
5. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards are properly
seated and then try again.
To install an IEEE-1394 card, reverse the previous steps.
To Next Page
Loading...
