HP xw4300 User Manual

Power Cord Set Requirements
141
E Power Cord Set Requirements
The power supplies on some computers have external power switches. The voltage select switch feature on the computer
permits it to operate from any line voltage between 100–120 or 220–240 volts AC. Power supplies on those computers
that do not have external power switches are equipped with internal switches that sense the incoming voltage and
automatically switch to the proper voltage.
The power cord set received with the computer meets the requirements for use in the country where you purchased the
equipment.
Power cord sets for use in other countries must meet the requirements of the country where you use the computer. For
more information on power cord set requirements, contact your authorized HP dealer, reseller, or service provider.
E.1 General Requirements
The requirements listed below are applicable to all countries:
• The power cord must be approved by an acceptable accredited agency responsible for evaluation in the country
where the power cord set will be installed.
• The power cord set must have a minimum current capacity of 10A (7A Japan only) and a nominal voltage rating
of 125 or 250 volts AC, as required by each country’s power system.
• The diameter of the wire must be a minimum of 0.75 mm
2
or 18AWG, and the length of the cord must be
between 1.8 m (6 feet) and 3.6 m (12 feet).
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from
the product.
WARNING! Do not operate this product with a damaged power cord set. If the power cord set is damaged in any
manner, replace it immediately.
E.1.1 Japanese Power Cord Requirements
For use in Japan, use only the power cord received with this product.
CAUTION: Do not use the power cord received with this product on any other products.
E.1.2 Country-Specific Requirements
Additional requirements specific to a country are shown in parentheses and explained below.
Country Accrediting
Agency
Country Accrediting
Agency
Australia (1)
Austria (1)
Belgium (1)
Canada (2)
EANSW
OVE
CEBC
CSA
Italy (1)
Japan (3)
Norway (1)
Sweden (1)
IMQ
METI
NEMKO
SEMKO
Denmark (1)
Finland (1)
France (1)
Germany (1)
DEMKO
SETI
UTE
VDE
Switzerland (1)
United Kingdom (1)
United States (2)
SEV
BSI
UL
1. The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 0.75mm
2
conductor size. Power cord set fittings
(appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the
country where it will be used.
2. The flexible cord must be Type SVT or equivalent, No. 18 AWG, 3-conductor. The wall plug must be a two-pole
grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A 250V) configuration.
3. Appliance coupler, flexible cord, and wall plug must bear a “T” mark and registration number in accordance with the
Japanese Dentori Law. Flexible cord must be Type VCT or VCTF, 3-conductor, 0.75 mm
2
conductor size. Wall plug must
be a two-pole grounding type with a Japanese Industrial Standard C8303 (7A, 125V) configuration.

HP xw4300 Specifications

General

Brand	HP
Model	xw4300
Category	Desktop
Language	English