Removal and Replacement Procedures70
4.20.2 PCI Card Support
For added protection, some cards have PCI holders installed to prevent movement during shipping.
To remove the card support:
1. Disconnect power from the system (section 4.2) and open the access panel (section 4.9).
2. Remove the two screws 1 retaining the card support and lift 2 it out of the chassis.
To install card support:
1. Disconnect power from the system (section 4.2) and open the access panel (section 4.9).
2. Engage the rear bracket 1 with the holes in the rear of the chassis before rotating it down 2 into position.
3. Secure the bracket with two screws 3.
To Next Page
Loading...
