Removal and Replacement Procedures84
2. Select a drive bay in which to install the drive.
3. Push the drive 1 into the selected bay until it snaps into place.
4. Attach the data 2 and power 3 cables to the drive.
5. Insert the SCSI controller card into an available PCI slot (section 4.20.4).
6. Connect the data cable from the hard drive 1 to the controller card 2.
7. Connect the hard drive LED cable from the card to the hard drive LED connector on the system board. You can
find the location of this connector on the illustration on the inside of the access panel.
To Next Page
Loading...
