Huawei RH8100 V3 - Page 191

● You have powered o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have installed the RAID controller card on the front I/O module. For
details, see 5.6.6 Installing a RAID Controller Card.
● You have installed the supercapacitor on the front I/O module. For details, see
5.6.8 Installing a Supercapacitor.
● You have installed the hard disk indicator panel on the front I/O module. For
details, see 5.6.10 Installing a Hard Disk Indicator Panel.
● You have installed the hard disk backplane on the front I/O module. For
details, see 5.6.12 Installing a Hard Disk Backplane.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for installing a front I/O
module.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Take out the front I/O module from the ESD bag and install the internal
components, such as the RAID controller card, supercapacitor, hard disk indicator
panel, and hard disk backplane.
Step 3 Hold the ejector levers of the front I/O module and push the module steadily into
the cabinet. See step (1) in Figure 5-64.
Step 4 Lower the ejector levers on both sides of the front I/O module. See step (2) in
Figure 5-64.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 181