● Phillips screwdriver
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Remove all cables from the hard disk backplane.
Step 3 Loosen the screws on the hard disk backplane. See step (1) in Figure 5-127.
Figure 5-127 Removing a hard disk backplane
Step 4 Remove the hard disk backplane in the arrow direction. See step (2) in Figure
5-127.
Step 5 Place the removed hard disk backplane in an ESD bag.
----End
5.8.12 Installing a Hard Disk Backplane
This topic describes how to install the front hard disk backplane.
Scenarios
Install the front hard disk backplane if the original one has failed.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the front I/O module from the RH8100 V3. For details, see
5.8.1 Removing the Front I/O Module.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 249
To Next Page
Loading...
