Step 12 Remove one side of the hard disk enclosure. See step (2) in Figure 5-89.
Step 13 Remove the hard disk backplane. See step (3) in Figure 5-89.
Step 14 Place the removed hard disk backplane in an ESD bag.
----End
5.6.12 Installing a Hard Disk Backplane
This topic describes how to install a hard disk backplane.
Scenarios
Install a hard disk backplane when it is faulty and needs to be replaced.
Prerequisites
Conditions
● You have powered o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the hard disk indicator panel. For details, see 5.6.9
Removing a Hard Disk Indicator Panel.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for installing the hard
disk backplane.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
● Phillips screwdriver
Hardware
Spare hard disk backplane
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Take the spare hard disk backplane out of its ESD bag.
Step 3 Install the hard disk backplane on the hard disk enclosure. See step (1) in Figure
5-90.
Step 4 Install one side of the hard disk enclosure. See step (2) in Figure 5-90.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 205
To Next Page
Loading...
