Figure 5-34 Installing an indicator board interface module
----End
5.5 Replacing the FM-A and Its Internal Components
This topic describes how to replace the front I/O module of model A (FM-A) and
its internal components.
5.5.1 Removing the Front I/O Module
This topic describes how to remove the front I/O module.
Scenarios
Remove the front I/O module if:
● The front I/O module has failed.
● A riser card on the front I/O module has failed.
● A PCIe card on the front I/O module has failed.
● A RAID controller card on the front I/O module has failed.
● An intelligent backup battery unit (iBBU) on the front I/O module has failed.
● A supercapacitor on the front I/O module has failed.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 149
To Next Page
Loading...
