Figure 5-63 Removing a front I/O module
Step 4 Remove the RAID controller card, supercapacitor, hard disk indicator panel, and
hard disk backplane from the front I/O module. Place the front I/O module in an
ESD bag.
For details, see 5.6.5 Removing a RAID Controller Card, 5.6.7 Removing a
Supercapacitor, 5.6.9 Removing a Hard Disk Indicator Panel, and 5.6.11
Removing a Hard Disk Backplane.
----End
5.6.2 Installing a Front I/O Module
This topic describes how to install a front I/O module.
Scenarios
Install a front I/O module if:
● The front I/O module has failed.
● A RAID controller card on the front I/O module has failed.
● A supercapacitor on the front I/O module has failed.
● A hard disk indicator panel has failed.
● A hard disk backplane has failed.
Prerequisites
Conditions
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 180
To Next Page
Loading...
