Huawei RH8100 V3 - 2.4 RH8100 V3 Indicators and Buttons

Table 2-11 Ports on HFC-2 of the rear panel
Name Typ
e
Quanti
ty
Single-
System
Mode
Dual-System
Mode
Description
VGA port DB1
5
1 Available Available The VGA port is
connected to a
display terminal,
such as a monitor.
USB port USB
2.0
2 Available Available The USB port is
connected to a
USB device.
iBMC
manageme
nt network
port
RJ45 1 Available Available The GE port is
used to manage
the server.
Serial port RJ45 1 Available Available Three-pin serial
port. The default
baud rate is
115200 bits/s.
This serial port is
used as the
system serial port
by default. You
can set it as the
iBMC serial port
on the iBMC CLI.
Network
port
- - Available Available The type and
quantity of
network ports
vary according to
the congured
LOM type.
In single-system mode, only the LOMs in the HFC-2 slot provide the NC-SI function.
2.4 Indicators and Buttons
This topic describes the RH8100 V3 indicators and buttons.
You can observe the indicators to determine RH8100 V3 status.
Table 2-12 describes the indicators and buttons on the RH8100 V3 front panel.
RH8100 V3 Server
User Guide 2 About the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 24