Step 3 Insert the TPM into the connector on the HFC. See step (1) in Figure 5-142.
Figure 5-142 Installing a TPM
Step 4 Tighten the screw on the TPM using a Phillips screwdriver. See step (2) in Figure
5-142.
----End
5.10.5 Removing a NIC
This topic describes how to remove a network interface card (NIC).
Scenarios
Remove a NIC if:
● The NIC has failed.
● The NIC needs to be replaced with a new model.
Prerequisites
Conditions
You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
Data
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 269
To Next Page
Loading...
