Huawei RH8100 V3 - Querying and Changing the Network Port Names of the Internal NIC

Figure 9-6 iBMC home page
NO TICE
The IP addresses 10.0.0.0 to 10.0.0.3 are reserved for internal use of iBMC. An
attempt to set the four IP addresses for ports by using the iBMC WebUI or CLI will
fail.
----End
9.3 Querying and Changing the Network Port Names
of the Internal NIC
This topic describes how to change the network port names of the internal NIC to
larger values (for example, eth87) to make the names
dier from the network
port names of any external NIC.
Ensure to meet the following conditions:
● The RH8100 V3 is in dual-system mode.
● The network ports on the internal NIC BCM5720 have been enabled in the
BIOS. For details, see "Miscellaneous
Conguration" in the Huawei Server
Brickland Platform BIOS Parameter Reference .
● The RH8100 V3 is powered on.
● You have logged in to the command-line interface (CLI) of the RH8100 V3
operating system (OS). This topic uses Linux as an example.
RH8100 V3 Server
User Guide 9 Common Operations
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 363