Huawei RH8100 V3 - Removing a Riser Card

Step 4 Ensure that the ejector lever is engaged with the left partition board in the front
I/O module, and close the ejector lever to completely insert the hard disk into the
front I/O module. See step (2) in Figure 5-38.
----End
5.5.5 Removing a Riser Card
This topic describes how to remove a riser card.
Scenarios
Remove a riser card if:
● The riser card has failed.
● A PCIe card on the riser card has failed.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the front I/O module from the RH8100 V3. For details, see
5.5.1 Removing the Front I/O Module.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a riser
card.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
● M3 Phillips screwdriver
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Press the button on the cover of the front I/O module. See step (1) in Figure 5-39.
Step 3 Remove the cover from the front I/O module in the arrow direction. See step (2)
in Figure 5-39.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 156