Figure 5-106 Installing a hard disk backplane
Step 5 Connect all cables to the hard disk backplane.
----End
5.8 Replacing the FM-D and Its Internal Components
This topic describes how to replace the front I/O module of model D (FM-D) and
its internal components.
5.8.1 Removing the Front I/O Module
This topic describes how to remove the front I/O module.
Scenarios
Remove the front I/O module if:
● The front I/O module has failed.
● A RAID controller card on the front I/O module has failed.
● A supercapacitor on the front I/O module has failed.
● The hard disk backplane on the front I/O module has failed.
Prerequisites
Conditions
You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
Data
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 225
To Next Page
Loading...
