● You have removed the rear I/O module from the RH8100 V3. For details, see
5.11.1 Removing a Rear I/O Module.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a PCIe
card.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Press the latch on the cover of the rear I/O module in the arrow direction. See step
(1) in Figure 5-161.
Step 3 Open the cover of the rear I/O module. See step (2) in Figure 5-161.
Step 4 Lift the PCIe card slowly out of the slot. See step (3) in Figure 5-161.
Figure 5-161 Removing a non-hot-swappable PCIe card
Step 5 Place the removed PCIe card in an ESD bag.
----End
5.11.6 Installing a Non-Hot-Swappable PCIe Card
This topic describes how to install a non-hot-swappable PCIe card.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 295
To Next Page
Loading...
