Huawei RH8100 V3 - Removing a USB Flash Drive

----End
5.10.7 Removing a USB Flash Drive
This topic describes how to remove a USB ash drive.
Scenarios
Remove a USB
ash drive if:
● The USB ash drive has failed.
● The USB ash drive needs to be replaced with a new model.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the High-performance Fusion Console (HFC) from the
RH8100 V3. For details, see 5.10.1 Removing an HFC.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a USB
ash
drive.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Remove the USB
ash drive from the connector on the HFC. See Figure 5-145.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 272