Prerequisites
Conditions
You have powered o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing the rear
I/O module.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Push the release buttons inwards. See step (1) in Figure 5-149.
The ejector levers eject automatically.
Step 3 Raise both ejector levers on the rear I/O module. See step (2) in Figure 5-149.
Step 4 Slowly pull out the rear I/O module while holding the ejector levers. See step (3)
in Figure 5-149.
Step 5 Remove the rear I/O module while holding the recessed handles on both sides.
See step (4) in Figure 5-149.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 279
To Next Page
Loading...
