Huawei RH8100 V3 - Page 384

Sensor Description Remarks
SAS Cable Entity presence This sensor exists when an 8- or
24-disk backplane is congured.
DISK N Disk status Hard disk. N indicates the physical
disk slot number.
PS N Status PSU fault status PSU. N indicates the PSU ID. The
value ranges from 1 to 4.
PS N Fan Status PSU fan status
PS N Temp
Status
PSU high-temperature
alarm sensor
RAID N Status RAID controller card
health status
RAID controller card. N indicates
the RAID controller card ID.
Port N Link
Down
NIC2NIC network port
link status
This sensor exists only when a
LOM is installed on the slave node
in a single system. N indicates a
port number.
BkpB MISC
Cable
Connection status of
the MISC cable to hard
disk backplane B
This sensor exists when a 24-disk
backplane is congured.
BkpC MISC
Cable
Connection status of
the MISC cable to hard
disk backplane C
This sensor exists when a 24-disk
backplane is congured.
Bkp MISC Cable Connection status of
the MISC cable to the
hard disk backplane
This sensor exists when an 8-disk
backplane is congured.
RAID N Temp RAID controller card
temperature
This sensor is available except for
the LSI SAS2308 RAID controller
card.
CPU N MEM
Temp
CPU DIMM
temperature
DIMM corresponding to the CPU.
N indicates the CPU ID. The value
ranges from 1 to 8.
HDDBkp Temp Hard disk backplane
temperature
This sensor exists when an 8-disk
backplane is congured.
EXP N Status Expander status This sensor exists when the front
I/O backplane of 12 or 24 disks is
installed. N indicates the sensor ID.
SD1 CARD SD card health status. SD card 1
SD2 CARD SD card 2
Heartbeat Master and slave
heartbeat sensors
N/A
N indicates the ID of the
component.
PCIe Status PCIe status error
RH8100 V3 Server
User Guide A Appendix
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 374