Powermax65/85/105 SYNC Troubleshooting Guide 810430 63
Troubleshooting for Common Problems
This section is for common troubleshooting problems that do not include fault codes.
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electric power before doing installation or maintenance. You can
get a serious electric shock if electric power is not disconnected. Electric
shock can seriously injure or kill you.
All work that requires removal of the plasma power supply outer cover or
panels must be done by a qualified technician.
Refer to the Safety and Compliance Manual (80669C) for more safety
information.
WARNING
INSTANT-ON TORCHES – PLASMA ARC CAN CAUSE INJURY, BURNS
Ignition of the plasma arc occurs immediately when you pull the torch trigger. Before
changing the cartridge, one of the following steps is necessary. Whenever possible,
complete the first step.
Set the power switch on the plasma power supply to OFF (O).
OR
Move the torch-lock switch to the yellow lock (X) position. Pull the trigger to make
sure that the torch does not fire a plasma arc.
To Next Page
Loading...
Need help?
General
