Need help?Do you have a question about the Hypertherm XPR300 and is the answer not in the manual?
General| Cutting Current | 300 A |
|---|---|
| Duty Cycle | 100% at 300 A |
| Technology | X-Definition Plasma |
| Gas Supply | Oxygen, Nitrogen, Air |
| Cutting Capacity (Mild Steel) | 38 mm (1.5 in) |
| Severance Capacity (Mild Steel) | 75 mm (3 in) |
| Pierce Capacity (Mild Steel) | 50 mm (2 in) |
| Input Voltage | 200–480 V, 3-PH, 50/60 Hz |
To Previous Page
