Icom IC-7800

5-17
5
FUNCTIONS FOR RECEIVE
■ Dualwatch operation
Dualwatch monitors 2 frequencies simultaneously.
The IC-7800 has 2 independent receiver circuits so
that you can use dualwatch with no compromises,
even on different bands and modes.
[MAIN]
[DUALWATCH][CHANGE] Sub dial[AF] for sub
[SPLIT][SUB]
q Set the desired frequency and mode into the main
band.
w Push [DUALWATCH].
 •“ ” appears.
 •Holding down [DUALWATCH] for 1 second, the sub
band is equalized at the same time. This quick dualwatch
function can be turned OFF in set mode. (p. 12-15)
e Rotate the sub dial to set the desired frequency.
r Push [SUB] to enables the sub band access when
changing the frequency band, operating mode, etc.
in sub band.
 •Push[MAIN]forthemainbandaccess.
t Rotate [AF] for sub band to adjust the sub band
audio level.
y To transmit on the sub band readout, push
[CHANGE] or [SPLIT].
NOTE:
•Abeatnotemaybehearddependingonthefre-
quency combination.
•Receiversensitivitywillbedecreasedwhenthe
same frequency band and the same antenna are
selected during dualwatch.
•TheRITfunctioncanbeusedforthemainread-
out only.
•The∂TX function can be used for the transmit
readout (main readout when the split function
OFF; sub readout when the split function ON).
• Split frequency operation during dualwatch