Icom IC-7800 - Sending a recorded message

7-11
7
VOICE RECORDER FUNCTIONS
■ Sending a recorded message
D Single TX
[F-1•T1] [F-2•T2] [F-3•T3] [F-4•T4] [EXIT/SET] [F-7•T/R]
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Push [SSB] or [AM/FM] to select a phone mode.
ePush [F-2•VOICE] to enter the Voice Recorder
menu.
r Push[F-1•PLAY]tocalluptheVoiceRecorderscreen.
 •If the receive voice memory channel appears, push
[F-7•T/R]toselectTXmemorychannel(T1–T4).
tPushadesiredmemorychannelswitch,[F-1•T1]to
[F-4•T4],totransmittherecordedvoiceaudio.
Appears
  •Thetransceivertransmitsautomatically.
 •“
” indicator appears and the memory timer
counts down.
 •Youhearthetransmittedmessagefromthespeakeras
the default setting. This can be turned OFF in voice set
mode. (p. 7-13)
yPushtheselectedmemorychannelswitch,[F-1•T1]
to[F-4•T4],againtostop,ifdesired.
 •Thetransceiverreturnstoreceiveautomaticallywhenall
of the recorded contents in the channel are transmitted.
u Push [EXIT/SET] twice to exit the voice memory screen.
D Repeat TX
[F-1•T1] [F-2•T2] [F-3•T3] [F-4•T4] [EXIT/SET] [F-7•T/R]
q Perform the steps q to r above.
w Hold down a desired memory channel switch,
[F-1•T1] to [F-4•T4], for 1 second to repeatedly
transmit the recorded voice audio for up to 10 min-
utes at the interval specified in “Repeat Time.”
 •Evenif10minutespasswhiletransmitting,thevoice
audio is completely transmitted.
 •Oneofthefollowingstepswillcancelthetransmission.
- Push the memory again.
  -Pushanothermemory(exceptfor[TXLEV.]).
Appears Repeat indicator
  -ExittheTXVoicememoryscreen.
- Turn OFF the power, then turn it ON again.
- Activate the transmission.
The repeat transmission is cancelled. But while trans-
mitting, the voice audio is completely transmitted.
 •OncetheRepeatTXismade,thetransceiverpauses
until the end of the “Repeat Time,” then transmits again.
After the second transmission, the Repeat TX continues
pausing, if receiving a signal. But if the squelch is man-
ually opened, the voice audio is repeatedly transmitted,
according to the repeat time setting.
✔ For your convenience
When an external keypad or PC keyboard is connected, the recorded message, T1 to T4, can be transmitted
withoutopeningtheVoiceRecorderscreen.Seepages2-6,2-10and12-20fordetails.
•Therecordedmessage,T1toT4istransmittedoncewhenpushingoneoffourswitchesontheexternalkeypad;there-
corded message is repeatedly transmitted when holding down a switch.
•Therecordedmessage,T1toT4istransmittedoncewhenpushingoneof[F1]to[F4]keyonthePCkeyboard;there-
corded message is repeatedly transmitted when pushing a key while holding down [SHIFT] key.