Icom IC-7800 - Memory channel programming

8-4
■ Memory channel programming
Memory channel programming can be preformed ei-
therinVFOmodeorinmemorymode.
D Programming in VFO mode
[Y] [Z] [MW]
q Set the desired frequency, operating mode and filter
widthinVFOmode.
w Push [Y]/[Z] several times to select the desired
memory channel.
 •Memorylistscreenisconvenientforselectingthede-
sired channel.
 •Memorychannelcontentsappearinthememorychan-
nel readout (below the frequency readout).
 •“--.---.--”appearsiftheselectedmemorychannelisa
blank channel (and does not have contents).
e Hold down [MW] for 1 second to program the dis-
played frequency, operating mode, etc., into the
memory channel.
D Programming in memory mode
q Select the desired memory channel with [Y]/[Z] in
memory mode.
 •Memorychannelcontentsappearinthememorychan-
nel readout (below the frequency readout).
 •“--.---.--”appearsiftheselectedmemorychannelisa
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
 •Toprogramablankchannel,usedirectfrequencyentry
with the keypad or memo pads, etc.
e Hold down [MW] for 1 second to program the dis-
played frequency and operating mode into the
memory channel.
8
MEMORY OPERATION
or
Hold down for 1 second.
Beep
Beep
Beep
[EXAMPLE]: Programming 7.088 MHz/LSB into memory
channel 12.
or then
Hold down for 1 second.
Beep
Beep
Beep
[EXAMPLE]: Programming 21.280 MHz/USB into memory
channel 18.