Icom IC-7800 - Firmware update- Memory device

16-4
■ Firmware update— Memory device
When updating the firmware using with the memory
device, no IP address as well as subnet mask settings
are necessary.
[F-1•Y]/[F-1•DIR/FILE]
[F-3•FIRM UP]/[F-3•Z]
[F-6•OK]
[F-7•SET]/[F-7•CF/USB]
/[F-7•CANCEL]
[F-2•Z]/[F-2•Y] [F-4•FIRM UP]
[EXIT/SET]
q Copy the downloaded firmware data into the mem-
ory device (“IC-7800” folder).
 •ThememorydevicemustbeformattedbytheIC-7800.
w Insert the CF memory card into the CF card slot or
connect the USB flash drive to the [KEY BOARD].
e Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
rPush[F-7•SET]toselectsetmodemenuscreen.
tPush[F-7•CF/USB]toselecttheCF/USB-Memory
set menu.
yHolddown[F-3•FIRMUP]for1second.
u Read the displayed precaution carefully.
 •Push[F-1•Y]or[F-2•Z] to scroll the indication.
 •Push[F-7•CANCEL]tocancelthefirmwareupdating.
i After you read and agree to all of the precautions,
push[F-6•OK].
 •[F-6•OK]appearsonlywhentheendoftheprecautionis
displayed.
 •Push[F-7•CANCEL]tocancelthefirmwareupdating.
oHolddown[F-3•DIR/FILE]toselectthememoryde-
vice.
!0Push[F-2•Y]or[F-3•Z] to select the firmware file,
thenpush[F-4•FIRMUP].
!0 Read the displayed precaution carefully.
!1Ifyouagree,holddown[F-6•OK]for1secondto
start the firmware update.
 •Push[F-7•CANCEL]tocancelthefirmwareupdating.
!2 While loading the firmware from the memory device,
the dialog as at left is displayed.
16
UPDATING THE FIRMWARE