Icom IC-7800

3-14
3
BASIC OPERATIONS
D Programming the user band edge
q Select the Others set mode and select the “Beep
(Band Edge)” option.
w Rotate the main dial to select either the “ON (User)”
or“ON(User)&TXLimit”setting.
 •[BAND]appearsabove[F-5].
ePush[F-5•BAND]toopenthebandedgescreen.
rPush[F-1•Y]or[F-2•Z] to select the desired band
edge.
 •Push[F-3•Ω ≈] to select the upper and lower band edge
frequency entry cell.
 •Push[INS]toinsertanewblankbandedgeline.
 •Holddown[DEL]for1secondtodeletetheselected
band edge line.
tPush[F-INP•ENT],andtheninputthedesiredfre-
quency with the keypad.
 •Push[GENE•]toinputdecimalpoint(“.”)betweenthe
MHz and kHz digits.
 •Programeachchannelfromlefttorightandeachfre-
quency must be higher than the preceding frequency.
 •Thefrequencythatisduplicated,oroutofanamateur
band, cannot be programmed.
 •Ifyouwanttoreturnthebandedgefrequenciestotheir
default(initial)value,holddown[F-4•DEF]for1sec-
ond.
The band edge initialize screen appears as shown
below,thenholddown[F-6•OK]for1secondtoinitial-
ize all band edge frequency settings.
yPush[F-INP•ENT]tosettheinputfrequency.
u Push [EXIT/SET] to exit the set mode.
Appears when “ON (User)” or “ON (User) & TX Limit” is
selected.
•Bandedgescreen