Icom IC-7800 - Memory scan operation

9-6
■ Memory scan operation
[SQL] for main [F-1•MEMO] [EXIT/SET] Main dial
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
ePush[F-5•SCAN]toselectthescanscreen.
r Set the main band’s [SQL] open or closed.
 •Seepage9-2forsquelchcondition.
tPush[F-1•MEMO]tostartthememoryscan.
•“ ” and decimal points blink while scan-
ning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
uTocancelthescan,push[F-1•MEMO].
 •Rotatingthemaindialalsocancelsthescan.
2 or more memory channels must be programmed
for memory scan to start.
■ Select memory scan operation
[SQL] for main [F-1•MEMO]
[F-3•SELECT]
[F-5•SEL No.]
[EXIT/SET] Main dial
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
ePush[F-5•SCAN]toselectthescanscreen.
r Set the main band’s [SQL] open or closed.
 •Seepage9-2forsquelchcondition.
tPush[F-5•SELNo.]severaltimestoselectthese-
lect scan number from ★1, ★2, ★3 and ★1/★2/★3.
yPush[F-1•MEMO]tostartthememoryscan.
•“ ” and decimal points blink while scan-
ning.
uPush[F-3•SELECT]tostartselectmemoryscan;
push[F-3•SELECT]againtoreturntomemoryscan,
if desired.
• “ ” blinks instead of “ ”
during select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
oTocancelthescan,push[F-1•MEMO].
 •Rotatingthemaindialalsocancelsthescan.
2 or more memory channels must be designated as
select memory channels, as well as the same select
scan number, for select memory scan to start.
9
SCANS