Icom IC-7800

4-10
D Contest number set mode
This menu is used to set the contest (serial) number
and count up trigger, etc.
• Setting contents
[F-1•Y] Main dial[EXIT/SET][F-2•Z][F-4•DEF]
qDuringCWmodeoperation,push[F-3•KEYER]to
select memory keyer screen.
wPush[EXIT•SET]toselectmemory keyermenu,
thenpush[F-3•001]toselectcontestserialnumber
set mode.
ePush[F-1•Y ]or[F-2•Z] to select the desired set
item.
r Set the desired condition using the main dial.
 •Holddown[F-4•DEF]for1secondtoselectthedefault
condition or value.
• Contest number set mode screen t Push [EXIT/SET] twice to normal screen.
4
RECEIVE AND TRANSMIT
This item sets the numbering system used for contest
(serial) numbers— normal or short morse numbers.
 •Normal :Doesnotuseshortmorsenumbers
(default)
•190➔ANO : Sets 1 as A, 9 as N and 0 as O.
•190➔ANT : Sets 1 as A, 9 as N and 0 as T.
•
90➔ NO : Sets 9 as N and 0 as O.
• 90➔ NT : Sets 9 as N and 0 as T.
This selects which of the four memories will contain
the contest serial number exchange. The count-up
trigger allows the serial number to automatically in-
cremented after each complete serial number ex-
change is sent.
 •M1,M2,M3andM4canbeset.(default:M2)
This item shows the current number for the count-up
trigger channel set above.
•Rotatethemaindialtochangethenumber,orhold
down[F-3•001CLR]for1secondtoresetthecur-
rent number to 001.