Icom IC-7800

6-3
■ Break-in function
The break-in function is used in CW mode to auto-
matically toggle the transceiver between transmit and
receive when keying. The IC-7800 is capable for full
break-in or semi break-in.
D Semi break-in operation
During semi break-in operation, the transceiver selects
transmit when keying, then automatically returns to re-
ceive after a pre-set time after you stop keying.
q Push [CW] to select CW or CW-R mode.
wPush[VOX/BK-IN]severaltimestoturnthesemi
break-in function ON.
•“BKIN”appears.
e Rotate [DELAY] to set the break-in delay time (the
delay from transmit to receive).
When using a paddle, rotate [KEY SPEED] to ad-
just the keying speed.
D Full break-in operation
During full break-in operation, the transceiver automat-
ically selects transmit while keying and returns to re-
ceive immediately after keying is finished.
q Push [CW] to select CW or CW-R mode.
wPush [VOX/BK-IN] several times to turn the full
break-in function ON.
•“F-BKIN”appears.
When using a paddle, rotate [KEY SPEED] to ad-
just the keying speed.
6
FUNCTIONS FOR TRANSMIT
[KEY SPEED] (inner control) [DELAY] (outer control)
[VOX/BK-IN] [CW]