Icom IC-7800

8-2
■ Memory channels
The transceiver has 101 memory channels. Memory
mode is very useful for quickly changing to often-used
frequencies.
All 101 memory channels are tunable which means
the programmed frequency can be tuned temporarily
with the main dial, etc. in memory mode.
■ Memory channel selection
D Using the [Y]/[Z] keys
[Y] [Z] [V/M]
qPush[V/M]toselectmemorymode.
w Push [Y]/[Z] several times to select the desired
memory channel.
 •Holddown[Y]/[Z] for continuous selection.
 •[UP]and[DN]onthemicrophonecanalsobeused.
eToreturntoVFOmode,push[V/M]again.
D Using the keypad
[Y] [Z] [V/M]
Keypad
[F-INP• ENT ]
qPush[V/M]toselectmemorymode.
wPush[F-INP•e n t ].
e Push the desired memory channel number using
the keypad.
 •Enter100or101toselectscanedgechannelP1orP2,
respectively.
r Push [Y] or [Z] to select the desired memory chan-
nel.
[EXAMPLE]
To select the memory channel 3;
-Push[F-INP•
e n t ],[7•3],thenpush[Y] or [Z].
To select the memory channel 12;
-Push[F-INP•
e n t ],[1.8•1],[3.5•2],thenpush[Y] or
[Z].
To select the scan edge channel P1;
-Push[F-INP•
e n t ],[1.8•1],[50•0],[50•0],thenpush
[Y] or [Z].
To select the scan edge channel P2;
-Push[F-INP•
e n t ],[1.8•1],[50•0],[1.8•1],thenpush
[Y] or [Z].
8
MEMORY OPERATION
MEMORY
MEMORY
TRANSFER OVER-
CHANNEL
CHANNEL CAPABILITY
TO VFO WRITING
CLEAR
NUMBER
Regular memory
1–99
One frequency and one mode
Yes Yes Yes
channels in each memory channel.
Scan edge
One frequency and one mode in
memory P1, P2 each memory channel as scan Yes Yes No
channels edges for programmed scan.