Icom IC-7800 - File loading

12-31
12
SET MODE
■ File loading
By loading the saved setting file from the memory de-
vice, you can easily set up another IC-7800— sev-
eral operators settings can easily be applied to one
IC-7800.
[F-1•DIR/FILE]
[F-5•OPTION][F-4•LOAD]
[F-6•SORT]/[F-6•OK]
[F-7•WIDE]/[F-7•CANCEL]
[F-3•Z][F-2•Y]
[EXIT/SET]
qDuringsetmodemenuindication,push[F-7•CF/
USB] to select CF/USB-Memory set menu screen.
wPush[F-1•LOAD]toselectsettingloadscreen.
eHolddown[F-1•DIR/FILE]for1secondtoselectthe
CF memory card or USB flash drive, if necessary.
 •Eitherthe“ ” or “ ” indicator blinks.
 •Afterthememorycontentsaredisplayed,theindicator
stops blinking.
rPush[F-5•OPTION]toselectloadoptionsetmode,
then set the desired loading conditions, if desired.
 •Seepage12-29fordetails.
tPush[F-2•Y]or[F-3•Z ] to select the desired set-
ting file.
yPush[F-4•LOAD].
 •TheConfirmationwindowappears.
uPush[F-6•OK]tostartsloading.
 •Aftertheloadingiscompleted,themessagedialog,“Re-
boot the IC-7800,” appears.
i Turn the transceiver power OFF then ON to make
the setting effective.