Icom IC-7800 - Page 89

5-5
D Scope set mode (continued)
5
FUNCTIONS FOR RECEIVE
Turn the peak level holding function ON or OFF.
Select the center frequency of the spectrum scope in-
dication (center mode only).
 •Filtercenter :Showstheselectedfilter’scenter
frequency at the center.
 •CarrierPointCenter
: Shows the selected operating
mode carrier point frequency at
the center.
 •CarrierPointCenter(Abs.Freq.)
: In addition to the carrier point
center setting above, the actual
frequency is displayed for the
bottom of the scope.
Set the waveform color for the currently received sig-
nals.
•ThecolorissetinRGBformat.
•Push[F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
•ThesetcolorisindicatedintheboxbesidetheRGB
scale.
Set the waveform color for the receiving signals max-
imum level.
•ThecolorissetinRGBformat.
•Push[F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
•ThesetcolorisindicatedintheboxbesidetheRGB
scale.
Select the outline indication of the waveform for the
spectrum scope.
 •Fill :Thewaveformisdescribedbyonly
the color.
 •Fill+Line :Thewaveformisdescribedbythe
color and outline.
Set the waveform outline color for the currently re-
ceived signals.
•ThecolorissetinRGBformat.
•Push[F-3•Ω ≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
•ThesetcolorisindicatedintheboxbesidetheRGB
scale.
Set the waterfall display to ON or OFF.  •ON :Displaysthewaterfallofthespec-
trum scope.
 •OFF :Doesnotdisplaythewaterfall.