Icom IC-GM800 - Page 51

46
2001 NEW
7
7
DSC OPERATION
1
2
3
4
5
6
Quick Reference
8
9
10
11
12
13
14
15
16
17
5. Select a Group ID, or “Manual Input.”
(Example: GROUP 1)
NOTE: When you select “Manual Input” in this step,
push the keypad to manually enter a Group ID.
Information
• The “Category” is  xed to “Routine.”
• When you have manually entered a Group ID, push the
keypad to manually select the DSC call frequency.
1.
Select “Call Frequency.”
2. Select a DSC call frequency, or “Manual Input.”
(Example: INTER2-1)
NOTE: When you select “Manual Input” in this
step, push the keypad to manually enter the DSC
call frequency.
6. Select “Comm Frequency.”
7. Select a communication frequency, or “Manual
Input.”
(Example: SHIP 2M)
NOTE: When you select “Manual Input” in this
step, push the keypad to manually enter a
communication frequency.
8. Push [Call]
to send the Group call.
9. After sending, the following screen is displayed.
 See page 29 for details of the software key functions
in the DSC Task mode.
10. Hold down [PTT] to communicate.
11. Push [Standby Mode] to return to the
Standby mode.
Rotate
+
Push
CH/GRP
Rotate
+
Push
CH/GRP
Rotate
+
Push
CH/GRP
Rotate
+
Push
CH/GRP
Rotate
+
Push
CH/GRP
Push