Icom IC-GM800 - D Receiving a Polling Request Call; D Receiving a Test Call

66
2001 NEW
7
7
DSC OPERATION
1
2
3
4
5
6
Quick Reference
8
9
10
11
12
13
14
15
16
17
D Receiving a Polling Request call
NOTE: When “Polling ACK” is set to “Auto,” the
transceiver automatically replies to the call. In that
case, both the TX and RX calls are stored in the
Transmitted and Received Call Logs. (Default: Auto)
1. When a Polling Request call is received:
• Alarm sounds.
• The following screen is displayed and the backlight
blinks.
• “
” is displayed and “ ” blinks.
Push [Alarm Off]
2. Select your desired action.
[Hold]: Push [Hold] to return to the Main
screen.
[ACK] Push [ACK] to send an
acknowledgement.
[Accept]: Push [Accept] to enter the DSC
Task mode.
L Rotate [CH/GRP] to conrm the call contents.
L See page 29 for details of the Software key
functions in the DSC Task mode.
3. Push [Standby Mode] to return to the
Standby mode.
TIP: See page 52 for details on sending an
acknowledgement.
D Receiving a Test call
NOTE: When “Test ACK” is set to “Auto,” the
transceiver automatically replies to the call. In that
case, both the TX and RX calls are stored in the
Transmitted and Received Call Logs. (Default: Auto)
1. When a Test call is received:
• Alarm sounds.
• The following screen is displayed and the backlight
blinks.
• “
” is displayed and “ ” blinks.
Push [Alarm Off] .
2. Select your desired action.
[Hold]: Push [Hold] to return to the Main
screen.
[ACK] Push [ACK] to send an
acknowledgement.
[Accept]: Push [Accept] to enter the DSC
Task mode.
L Rotate [CH/GRP] to conrm the call contents.
L See page 29 for details of the Software key
functions in the DSC Task mode.
3. Push [Standby Mode] to return to the
Standby mode.
TIP: See page 53 for details on sending an
acknowledgement.
Push
any