Icom IC-GM800 - D Receiving a Position Request Call; D Receiving a Position Request; Acknowledgement

65
2001 NEW 2001 NEW
DSC OPERATION
7
■ Receiving DSC calls
D Receiving a Position Request call
NOTE: When “Position ACK” is set to “Auto,” the
transceiver automatically replies to the call. In that
case, both the TX and RX calls are stored in the
Transmitted and Received Call Logs. (Default: Manual)
1. When a Position Request call is received:
• Alarm sounds.
•
The following screen is displayed and the backlight blinks.
• “ ” is displayed and “ ” blinks.
Push [Alarm Off] .
2. Select your desired action.
[Hold]: Push [Hold] to return to the Main
screen.
[ACK] Push [ACK] to send an
acknowledgement.
[Accept]: Push [Accept] to enter the DSC
Task mode.
L Rotate [CH/GRP] to conrm the call contents.
L See page 29 for details of the software key functions
in the DSC Task mode.
3. Push [Standby Mode] to return to the
Standby mode.
TIP: See page 51 for details on sending an
acknowledgement.
D Receiving a Position Request
acknowledgement
1. When a Position Request acknowledgement is
received:
• Alarm sounds.
• The following screen is displayed and the backlight
blinks.
• “
” is displayed.
Push [Alarm Off] .
2. Push [Close Call RCVD Window] .
L Rotate [CH/GRP] to conrm the call contents.
L See page 29 for details of the software key functions
in the DSC Task mode.
3. Push [Standby Mode] to return to the
Standby mode.
Push
any