Icom IC-GM800 - Using the Optional MB-108

83
2001 NEW 2001 NEW
CONNECTIONS AND INSTALLATION
9
■ Using the optional MB-108
The optional MB-108 mounting bracket can be used
to mount the transceiver’s main unit. The
MB-108 provides one-touch attachment or
detachment.
CAUTION: Wear gloves when installing the
MB-108. The edges of the MB-108 may be sharp
and may easily cut your ngers or hands.
1. Attach the mounting handles with the supplied
hex head bolts (M6×15), spring and flat washers,
as shown below.
2. Drill 7 holes, 6 ~ 8 mm in diameter, using the
template supplied with the MB-108.
3. Attach the mounting base to a at surface using
the hex head bolts (M6×50), spring and at
washers, and nuts, supplied with the
MB-108, as shown below.
4. Mount the transceiver main unit with the mounting
handles attached, to the mounting base.
5. Lock the main unit in place by closing the
4 latches on the mounting handles.
z
x
Hex head bolt (M6×15)
Spring washer
Flat washer
Mounting
handle
Hex head bolt (M6×50)
Spring washer
Flat washer
Mounting
base
Flat washer
Spring washer
Nut (M6)