Icom ID-5100A

8
GPS OPERATION
8-37
Setting the GPS alarm (Continued) D
Example: Set the alarm setting to RX (RX/Memory).
Touch [MENU]. q
Touch “GPS Alarm.” w
(GPS > GPSAlarm)
• If the item is not displayed, touch [∫] or [√] one or more
times to select another page.
Touch “Alarm Select.” e
Touch “RX.” r
• If you want to set the alarm to a GPS memory channel,
touch “Memory,” and then touch “(No Group)” or “A” to
“Z.”
“RX” is displayed
Adding or editing GPS memory
NOTE:
Even if “RX” is selected in step r, and the received
signal has no position, the GPS alarm does not
sound.
Foryourreference:
When “RX” or a GPS memory channel is selected,
the alarm sounds depending on the “Alarm Area (RX/
Memory)” setting in the Menu screen.
(GPS > GPS Alarm > AlarmArea(RX/Memory))
Touch [MENU]. t
• Closes the Menu screen, and “ì” appears on the
screen.
• To cancel the GPS alarm, select “OFF” in the step r.
• When a station with its GPS alarm set enters within an
approximate 1 kilometer (1093 yard) range, the beep
sounds once. When it enters within an approximate 500
meter (546 yard) range, a beep sounds three times.
• When the GPS alarm sounds, “GPS ALARM” pops up on
the screen and then “ì” blinks.
GPS alarm sounds, and
“GPS ALARM” pops up.
Blinks
Previous view