Icom ID-5100A

12
MENU SCREEN
12-3
MenuitemsandDefaultsettings
NOTE:The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
DUP/TONE...
Settings to access repeaters.
Offset Freq 0.000~0.600.00*
1
~59.995 MHz Sets the frequency offset for duplex (repeater) op-
eration.
Repeater Tone 67.0~88.5~254.1 Hz Selects a tone frequency used to access the repeat-
ers.
TSQL Freq 67.0~88.5~254.1 Hz Selects a tone frequency for the Tone squelch or the
pocket beep function.
Tone Burst OFF or ON
Turns the Tone Burst function ON or OFF.
This function is used to suppress the squelch tail noise
heard from the transceiver’s speaker.
DTCS Code 023~754 Selects a DTCS (both encoder/decoder) code for
DTCS squelch or the pocket beep function.
DTCS Polarity BothN, TN-RR, TR-RN or Both R Selects the DTCS polarity for the DTCS squelch or
the pocket beep function.
Digital Code 00~99 Selects a digital code for the Digital Code squelch
function.
ManageMemory Manage your Memory or Call channel data.
Memory CH ALL, A~Z Manages for the Memory channels.
Call CH C0/C1(144):146.010 FM*
2
C0/C1(430):440.000 FM*
2
Manages for the Call channels.
Scan Set scan options.
Pause Timer 2sec~10sec~20sec or HOLD Selects the scan pause time. When receiving signals,
the scan pauses according to the scan pause timer.
Resume Timer 0sec~2sec~5sec or HOLD
Selects the scan resume time from a pause after the
received signal disappears.
Temporary Skip Timer 5min, 10min or 15min Selects the Temporary Skip Time. When the time is
set, specified frequencies are skipped for this period
during a scan.
Program Skip OFF or ON Turns the Program Skip Scan function ON or OFF for
a VFO mode scan.
Bank Link
A:
✔
~Z:
✔
Selects banks to be scanned during a Bank Link
Scan.
Program Scan Edge 00~24 Sets the frequency ranges for the program scan.
Program Link
See page 12-15 for details of the preset values.
Sets the link function for the program scan edge
channels.
VoiceMemo Set the TX/RX voice recording options.
QSO Recorder
<<REC Start>>*
3
Starts recording the received signal audio.
Play Files*
3
PLAY FILES Plays or deletes the recorded audio.
Recorder Set
REC Mode TX&RX or RX Only Selects to record the TX audio or not.
RX REC Condition Always or SquelchAuto Selects whether or not the squelch status affects the
RX voice audio recording.
File Split OFF or ON Selects whether or not to automatically create a new
file if transmission and reception, or squelch status
(open and close) is switched.
PTT Auto REC OFF or ON Turns the PTT Automatic Recording function ON or
OFF.
Player Set
Skip Time 3sec, 5sec, 10sec or 30sec
Sets the Skip time to rewind or forward the recorded
audio when you push the fast-rewind or fast-forward
key during playback.
*
1
The default value may differ, depending on the frequency band (selected as the MAIN band before entering the Menu screen)
and the transceiver version.
*
2
The default value may differ, depending on the transceiver version.
*
3
Be sure to insert the SD card into the transceiver before selecting these items.
Previous view