Icom ID-5100A

12
MENU SCREEN
12-19
VoiceTXitems
Record
Voice TX > Record
Up to one minute of audio can be recorded onto an SD
card for voice transmission. (p. 13-2)
Four independent voice audios can be memorized into
each memory T1 to T4.
While recording a QSO voice audio, this function is dis-
abled.
Be sure to insert an SD card into the card slot.
RepeatTime (Default:5sec)
Voice TX > TX Set > Repeat Time
Set the repeat time period to between 1 and 15 sec-
onds (in 1 second steps).
The transceiver repeatedly transmits the recorded
voice audio for this set time period.
NOTE:
The recorded voice audio is repeatedly transmitted
for up to 10 minutes.
If 10 minutes passes while transmitting, the trans-
ceiver continues to transmit until the complete voice
audio transmission is finished.
TXMonitor (Default:ON)
Voice TX > TX Set > TX Monitor
Turn the TX Monitor function ON or OFF.
• OFF: The TX voice audio is not heard from the speak-
er.
• ON: The TX voice audio is heard from the speaker.
<<TX>>
Voice TX > TX Set > <<TX>>
The transceiver transmits the recorded voice audio.
Touch the “Repeat TX” box to make a check mark to
repeatedly transmit the recorded voice audio for up to
10 minutes, at the specified interval in the Repeat Time
item. (p. 13-3)
NOTE:
• If 10 minutes passes while transmitting, the trans-
ceiver continues to transmit until the complete voice
audio transmission is finished.
• Any one of the following action will cancel the trans-
mission.
- Push [PTT].
- Turn OFF the power, then turn it ON again.
- Push any key (except for [VOL] and [ ]).
Previous view